PLC control panels built for your project, plus the site cabling, instruments and installation (the field works) that make a control system work, delivered by the same team that writes the programme.
WHAT IT IS
What it is, when you need it, what you get.
What it is
PLC control panels designed, built and tested in our workshop, plus the cabling, instruments and installation on site that connect them to your machines and plant.
When you need it?
You are adding a line or machine, an old controller is hard to support, or you want to see the whole plant on one screen.
What you get
A tested system that works on site, drawings and documents, and training so your team can run it.
HOW IT WORKS
From the workshop to the site, in four steps.
01
Design
We design the panel and its drawings around your machine or plant and the control programme.
02
Build and wire
The panel is built and wired in our workshop.
03
Test before it ships
We test the panel in our workshop (the factory acceptance test, FAT), so problems are found before it reaches your site.
04
Install and commission
We install the panel, connect the field wiring, instruments and networks, then commission it with you (the site acceptance test, SAT) and hand over.
TECHNICAL SCOPE
Panels, wiring and site installation.
PLC control panels
Design, build, test and installation, from single panels to multi-panel systems.
Control Programme
Written by the same team that builds the panel: PLC and HMI programming, Siemens TIA Portal preferably.
Field Wiring
Control and instrument field wiring.
Instruments
Instrument integration: devices that measure level, flow, pressure and temperature, connected to the control system.
Industrial networking
Installation of the control and instrument networks that connect the plant floor, using Siemens, Moxa and Teltonika networking equipment.
Field installation works
Installation of the panels, instruments and field devices on site, as one scope of work.
Testing
FAT in our workshop and SAT on site, then commissioning and handover.
PANEL AND SITE SCOPE
Panels, workshop and site work.
Closed front with touch screen
Panel front with touch screen and push buttons
Installed on site
Inside: neat, labelled wiring
Inside: PLC, power supplies and terminals
Compact enclosure with PLC
Wiring a panel in the workshop
Building a larger panel as a team
Testing in the workshop
ONE TEAM
Panel, programme and site work from one team.
The people who build your panel also write its programme and commission it on site. When something needs fixing, there is one team to call.
TECHNICAL
Panel design, PLC and HMI programming, field wiring, FAT, SAT and handover sit under one scope and one point of accountability.
RELATED
Related products and services.
Industrial control systems
The controller, screens, and software the panel runs.
Control systems support and maintenance
Support after commissioning.
Products
PLCs, drives, instruments and networking we use in this service.
For main contractors
Scope by discipline and delivery stages.
Tell us about the panel or the site.
Send us the machine or plant, the I/O list or specification if you have one, and your programme dates.